RSL1062 LaminatorOWNER'S MANUALRead all instructions carefully before use. For any Customer Support needs please choose the Customer Support t
996.3. MOUNTINGFigure 11. Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the release liner
RSS, RSR, RSH Series1010107. CONTROL OF ROLLER PRESSURETo set, pull the pressure lever outward and turn to one of the following positions.① OPEN: F
11118. CONTROL PANEL1. UPPER: To change upper roller temperature by pressing button, then up or down arrow. (range 32~302°F or 0~150°C)2.
RSS, RSR, RSH Series12121. Turn on the power switch located on the rear of the machine.2. Set the pressure lever to the "Laminating mode".3.
1313— Useful Information —1. You can preset up to 9 temperature and speed settings in the memory for faster easier use.2. When laminating continuou
RSS, RSR, RSH Series14149.2. COLD LAMINATING1. Put cold roll film on upper shaft. Load backing paper on the lower shaft as per illustration 6.2 on
151510. USING CROSS CUTTER1. After lamination, move the cutter approximately to the center of the completed application at the desired point
RSS, RSR, RSH Series1616Cleaning the Body of the laminatorTo clean the machine body, dampen a cloth with water only and gently wipe the machine clean.
171712. TROUBLESHOOTING Symptom Machine will not turn on:There is power, but therollers are not turning after the "RUN" button
RSS, RSR, RSH Series181813. Recommended Temperature and Speed Settings.NOTE: Speed and temperature should be adjusted in accordance with film manufact
1TABLE OF CONTENTSTOPIC PAGE1. Introduction ...
191914. SPECIFICATIONS Description RSL-1062 Power supply AC 220~230V 50/60Hz Power consumpt
20RS International Australia PTY. LTD.30 Prime Drive, Seven Hills, NSW 2147, AustraliaTEL : +61) 2-9674-2127 FAX : +61) 2-9674-2027E-mail : sal
RSL-10622 1. INTRODUCTION2. SAFETY PRECAUTIONSFailure to comply with any of the following safety procedures could result in serious injury. Please
33. PRODUCT IDENTIFICATION NO PART NAME NO PART NAME 1 UPPER FILM 7 LOWER FILM 2 TAKE-UP BOBBIN 8 GUIDE-DOCUMENT 3 IDLE BAR 9 HANDLE-TE
RSL-10624 4. INCLUDED WITH LAMINATORThoroughly inspect the parts and the unit. It is imperative that any missing parts are reported and a claim is fil
55. LOADING FILM1. As shown in picture 1, insert auto grips onto the upper/lower film shaft.2. As shown in picture 2, using the special tool, fix the
RSS, RSR, RSH Series666. THREADING FILM1. Turn the power switch on("I" position). Power switch is located in the rear of the unit on the le
78. Carefully pull up the laminate from the lower roll up towards the first idle bar and then around the back side of the second Idler (Cauti
RSS, RSR, RSH Series881. Follow the steps in the "Loading Film" procedure by loading the upper shaft with pressure sensitive film, e.g. (
Commentaires sur ces manuels