Royal Sovereign RSL1062 Manuel du propriétaire télécharger pdf (Page 15)

RSS, RSR, RSH Series

9.2. COLD LAMINATING

1. Put cold roll film on upper shaft. Load backing paper on the lower shaft as per

illustration 6.2 on page 7.

2. Pull COLD film and fix it so that the Release Liner can be wound on take-up

mandrel clockwise. (Revolve core to make Release Liner a little tight)

3. Set pressure lever to the proper position according to your laminating condition.

4. After pressing the button, choose and

set proper speed by using the and

button.

5. It is when ready is dispalyed

on the screen and beeps three times.

6. Turn on the take up device and set

the proper film tension by pressing

the"RUN "button. Lower tension

would make better operation.

7. Center the document on the table.

For ease and convenience set the

document guides in position

8. Press the"RUN "button and "take up

motor" at the same time.The liner and film

will roll at the same time.

9. When lamination is completed, press the button.

10. Set pressure lever at the "OPEN" mode.

11. Turn off the power switch.

RSL-1062

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Royal Sovereign RSL1062 Manuel du propriétaire Page 15