Royal Sovereign RSL1062 Manuel du propriétaire télécharger pdf (Page 9)

RSS, RSR, RSH Series

1. Follow the steps in the "Loading Film" procedure by loading the upper shaft with

pressure sensitive film, e.g. (Royal Print-Pro Film) and lower shaft with pressure

sensitive mounting adhesive films or backing paper

(Royal Sovereign White-Mount or Clear-Mount).

2. Pull the upper laminate under the upper idle bar and separate the release liner

from the laminate.

3. Tape the release liner to the Take-Up Paper Core and allow the laminate to hang

over the main rollers.

4. Pull up the mounting adhesive and tack it to the laminate hanging over the rollers

(do not use the Lower Idle Bar).

5. Reinstall the Front Table, and close the Safety Cover.

6. Adjust the nip setting to 1/4"(6mm).

7. Insert and push the leader board until board reaches the nip point.

8. Press the Run button and adjust the supply roll tension knobs by rotating clockwise or

counterclockwise. Turn it until the supply roll films have some resistance

(the tension varies depending on the thickness of a film; the thicker the film the more

tension is required).

9. Press Stop button when the leader board has completely exited the rear of the unit.

11. Use the Cross Cutter to cut the leader board from the web (see page18).

12. Set the roller nip setting to the appropriate position for the lamination application.

:'1+;6*+</)+

6'6+8(')1

8522

(')1/4-6'6+8

('9+,/23

25=+8/*2+('8

;66+8/*2+('8

)52*,/23

6.2. COLD FILM

RSL-1062

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Pas de commentaire

Royal Sovereign RSL1062 Manuel du propriétaire Page 9